Mini (in cabinet): 10.1.10.190

Printed a user print fine.

Mini #2: 10.1.10.52

Printed a user and a test print fine.  I changed out the user's filament.

Prusa (outside cabinet with blue left Z-rod holder):   10.1.10.185

Filament heat sink fan failed to start.  Replaced fan and also cleared a filament jam.  This machine is difficult to load filament as the little PTFE tube just after the stepper motor teeth seemed to have a jagged edge.  I need to get new tubes for both printers.  The trick for now is to cut new filament at an angle and try rotating the edge 90 per try until it loads more than 10mm before clicking (that is after removing the previous filament).

Prusa #2 (inside cabinet with orange left Z-rod holder):  10.1.10.167 

Filament was jammed.  Had to take it apart to clear out the broken piece.  The PTFE tube is in horrible shape on this machine as well.  Same trick is needed to load the filament as the other Prusa (see above).

Taz 3:   10.1.10.72

Printed a test print fine.

Taz 5:   10.1.10.168

X-axis bar was way tilted.  Leveled the bar (by turning one stepper) then fixed up the first layer height.  After this, it printed a test print fine.