I was there tonight and could not get my file to send over. Has anyone else had this problem?
Usually if you just try again it will usually just work.
If you have multiple copies of LightBurn open, it can confuse things; close them all and then open just one. This may include copies on multiple computers.
Just once, long ago, I needed to close all Lightburn, power cycle the LASER cutter, then re-open Lightburn.
Yes, I've seen things get corrupted at the laser cutter. Resetting the laser cutter has always worked for me.
The Fort Collins Creator Hub is a 501(c)3 non-profit organization.
info@fortcollinscreatorhub.org
http://www.fortcollinscreatorhub.org
Address:
1304 Duff Dr #11
Fort Collins, CO 80524
-lores-border.png){kind=logo}
