Fort Collins Creator Hub

Bandsaw table dimensions

  • 6 Nov 2019 8:57 PM
    Message # 8095709
    Stephen Warren (Administrator)

    Is there a spec for the dimensions of the bandsaw table; things like: width, height, profile/size of guide cutout and offset from the edge, location of blade tip from side/front? I couldn't see it in the manual online:-( If not, I guess I can measure it.

  • 7 Nov 2019 6:07 AM
    Reply # 8096241 on 8095709
    David Moore (Administrator)

    I can measure when I come in today, metric or merican?

  • 12 Nov 2019 11:15 PM
    Reply # 8104936 on 8095709
    Stephen Warren (Administrator)
    I wish this forum would subscribe me to the topics that I post so I know about replies! Anyway I'll be there tomorrow so I'll measure it then I guess.
  • 13 Nov 2019 7:41 AM
    Reply # 8105462 on 8095709
    Steve Undy (Administrator)

    There is a way to subscribe to specific forums.  See the Help page.

  • 13 Nov 2019 5:21 PM
    Reply # 8106677 on 8095709
    Stephen Warren (Administrator)

    Sure, there's a button to do so. I'd just expect that the default behaviour would be that anytime you create a topic, or anytime you reply to a topic, the default setting would be to subscribe. That's typical of forum SW, and exactly what your want 99% of the time.

  • 15 Nov 2019 8:07 AM
    Reply # 8109036 on 8095709
    Steve Undy (Administrator)

    Yes, it's not very good. We are seriously considering adding Slack as the primary member inter-communication platform.

The Fort Collins Creator Hub is a 501(c)3 non-profit organization.


1304 Duff Dr #11

Fort Collins, CO 80524

Powered by Wild Apricot Membership Software