Mini:
I installed the new bed leveling screws on the Mini (one was stripped and loose)
Prusa:
Prints do not stick to the bed. I left due to the storm before I had a chance to see what was going on but did have two prints in a row fail. The bed did warm up to temperature so I need to watch closer. The auto-level was fine and the first layer was flat but then skidded off.
Taz 5:
Found some strange white Ninja filament in the printer but was alterted to a Z-offset issue. I calibrated the Z-offset by turning the little knob next to the micro switch. The Z-offset had an error of about 10mm. The switch seems to dangle down so maybe the switch is starting to fail. I did a test print after the adjustment and things seemed fine.
Taz 3:
A nice looking large print was sitting on it when I came in. I removed it and had no trouble with a test print.
For the Prusa: any chance someone messed with the "live Z-height"? In the past, I've found that it had been completely changed to a value that prevented prints from adhering.
The Fort Collins Creator Hub is a 501(c)3 non-profit organization.
info@fortcollinscreatorhub.org
http://www.fortcollinscreatorhub.org
Address:
1304 Duff Dr #11
Fort Collins, CO 80524