Mini:
Working fine.
Prusa:
Found a lot of loose screws (Y-axis belt hold down had a screw completely out which made the bed very loose). Also found the fan redirection plastic screw was loose which let the plastic hit the bed. First test print went well but I'll do some more testing.
Taz 5:
Working fine
Taz 3:
Filament was jammed and the bed was a mess. I was able to yank the filament out and I cleaned the crap out of the bed and now it is working fine.
Hi,
On Saturday 3/30 I arrived to both taz5 and taz3 being inoperable. Taz5 had a note that the bed was not level.
On taz5 I power cycled everything and go it going. I printed 3 items for a total of 4 hours and all was fine.
On taz3 there was no filament. I tried loading the 3mm Fire pla but to no avail. I switched to a 3mm green pla and all was fine. I printed a short 3-4mm file and it was fine. I then tried a much taller file and the layers were off set. I let it run and with less than 10% left the printer seemed to just stop.
The non prez Steve knows of the issue but I forgot to put a note on taz3.
The Fort Collins Creator Hub is a 501(c)3 non-profit organization.
info@fortcollinscreatorhub.org
http://www.fortcollinscreatorhub.org
Address:
1304 Duff Dr #11
Fort Collins, CO 80524
-lores-border.png){kind=logo}
