Mini:
Pulled the print head apart and found some threads of filament. After putting it back together, it prints nicely again!
Mini #2:
Printed a large item nicely.
Prusa:
Fixed the loose belt on bed Y-axis (a little piece of paper to act as a wedge and fixed a messed screw on the front right corner of the bed. Re-calibrated the bed and head and it works nicely again.
Taz 3:
Print head is all jammed up. Taking it home to print out a new print body to rebuild the head. Should be fun.
Taz 5:
Printed a test print fine.
I meant to mention: About a 1/2 to 1 week ago I printed on the mini on the table. It printed perfectly, but movement in the X direction sounded like it was vibrating, and the filament certainly was. Not sure if that's normal or not, since I haven't used the 3D printers in a long time.
The Fort Collins Creator Hub is a 501(c)3 non-profit organization.
info@fortcollinscreatorhub.org
http://www.fortcollinscreatorhub.org
Address:
1304 Duff Dr #11
Fort Collins, CO 80524