LightBurn offers Flood Fill and Over-scanning controls in each layer’s control window. Flood Fill can greatly optimize the path and cut down on travel time. Over-scan allows the LASER to travel on smoother paths by giving it move distance to accelerate at path changes, which can really make for more consistent cutting and engraving. It is really apparent where there are sharp and frequent turns.
Anyhow, sorry if this is already known to everyone. I noticed that these two features, which are available on my personal version of LightBurn, are not present when connected to the Cam5. I’m guessing the Cam5 does not support these two features. Can anyone confirm this?
Matt
The Fort Collins Creator Hub is a 501(c)3 non-profit organization.
info@fortcollinscreatorhub.org
http://www.fortcollinscreatorhub.org
Address:
1304 Duff Dr #11
Fort Collins, CO 80524